Deltesian Double Bed, Double Rail - Testing the Gen 2 Conversion

 The plan: Convert the Y-Axis from 3 extrusion to 2 and move the timing belt from above to below the Carriage Plate.

The plan: Convert the Y-Axis from 3 extrusion to 2 and move the timing belt from above to below the Carriage Plate.

 A Final Look at the 3 Extrusion Double Bed

A Final Look at the 3 Extrusion Double Bed

 Visualizing the New Extrusions and Brackets compared to the existing Y-Axis

Visualizing the New Extrusions and Brackets compared to the existing Y-Axis

 Move Mock up visualization of the New Extrusions and Bracketry for the Y-Axis

Move Mock up visualization of the New Extrusions and Bracketry for the Y-Axis

 Removing the Rear Mounting Screws for the Bed

Removing the Rear Mounting Screws for the Bed

 Removing the Front Mounting Screws for the Bed

Removing the Front Mounting Screws for the Bed

 Double Bed removed from the XZ Frame.

Double Bed removed from the XZ Frame.

 XZ Frame w/o the Y-Axis

XZ Frame w/o the Y-Axis

 3 Extrusion Double Bed

3 Extrusion Double Bed

 Bottom of the 3 Extrusion Double Bed

Bottom of the 3 Extrusion Double Bed

 Top of the Assembled Y-Axis 

Top of the Assembled Y-Axis 

 Bottom of the Y-Axis. The belt runs underneath the Carriage Plate

Bottom of the Y-Axis.
The belt runs underneath the Carriage Plate

 Test fitting to the XZ Frame

Test fitting to the XZ Frame

 Full Frame Shot of the Test Fit.    That's if for the night! Bed install and printing tomorrow!

Full Frame Shot of the Test Fit.


That's if for the night! Bed install and printing tomorrow!